Causes of failure of the automatic stop device of the flowering machine

When the flowering machine is in use, when the automatic stop device of the flowering machine is used, if there is any reason for the failure, as a flowering machine manufacturer, let us understand the cause of the failure! 1. The thick strip does not stop, the reason is: 1. The horn head of the flowering locomotive is improperly used, the gauge is greater than the process requirements, and the thick strip control effect is lost. 2. The horn head spring is too hard or the distance from the thick rod contact is too large. 3. The thick strip is powered off when it contacts the electrical contact. 2. The reason why the thin strip and broken strip do not stop is: 1. The thin strip (or broken strip) is loosened from the surface of the flowering machine, and the contact is installed too low. When producing thin strips or broken strips, the contacts must not be touched. 2. The thin strip or broken strip contacts the electrical contact and loses power. 3. The flowering locomotive surface is electrically touched for no reason and the automatic stop fails. The reason is: 1. After the insulating sleeve of the conductive copper strip connected to the 6.3 volt control circuit is damaged, the vehicle rod or small lock plate will be electrocuted. 2. The installation distance of the electrical contacts in various parts is too close, or the thin contact screws are installed too low, almost touching the lower pressure shaft of the car, which may cause insulation damage, loss of insulation, leakage, etc. 3. Due to careless cleaning operation, the connection line between the 6.3V control circuit and the copper busbar is broken, causing all process contacts on the surface of the car body to lose power. 4. The occurrence of unexplained electric shock must be related to the unexplained electric shock in the automatic stop device of the rear drive small pressure roller and the rear unwinding white stop device, which cannot be ruled out.