Take you to have a deep understanding of the maintenance work of the opener that cannot be ignored

I believe that any equipment cannot ignore the daily maintenance work, and the opening machine equipment is no exception. The maintenance of this product is related to whether the equipment can stably maintain high-quality and high-yield operation. It is necessary to strengthen the management of staff, unify the operation methods, and put maintenance work into the normal production management track. Friends who want to know, please read the following content! Next, I will introduce to you how to perform effective maintenance in detail! 1. Cleaning work of the whole machine: 1. Open the protective cover outside the opener pressure gauge, open the control box, clean the whole car, blow off the flowers and hair in the electromagnetic clutch (this is the key part of the accident caused by the flame), and wipe off the oil stains around the pedal box. Clean the flowers and hair in the control box. 2. Loosen the warp yarn and remove the burrs under the heald and breast beam. Excessive hair at the bottom of the breast beam will damage the air pipe of the auxiliary nozzle. Too many flowers under the steel box can easily cause box channels or damage the front teeth. 3. Blow off the hair under the hinge of the heald frame, clean the oil stains under the cloth roller, blow off the hair on the side of the warp feeding motor, and then clean the machine. 4. Clean the weft storage device: clean the flying flowers in the winding reel and the floating flowers around the tensioner. 5. Clean the edge grinding machine of the opener belt: Cleaning the edge grinding machine head is the key to reducing the defects of the raw edge cloth, and it should be cleaned perfectly. 2. Check the leno device and tension device: 1. Remove the dust and accumulated flowers between the sliders on the edge of the yarn roller. 2. Check the guide pins and yarn guides to keep them smooth. 3. Check whether the pull-in is correct and whether the hinge edge works. 4. Check whether the tension proximity switch and damper work and whether the screws are loose. 3. Check the side support: 1. If conditions permit, the side support needs to be used. 2. If there is no problem, remove the side support and carefully check whether the teeth of the side support are bent or damaged. 3. Check whether the tooth ring of the side support rod rotates flexibly and remove the ring in the tooth ring. 4. Carefully check whether the two nylon rings are worn, because after the nylon ring is damaged, one will reduce the support effect and the other will produce wear marks on the surface of the cloth. 5. The assembly specifications of the side support should be strict. In particular, the cloth edge at the side support, the warp yarn at the edge of the steel frame and the warp yarn at the edge of the heald frame should be in a straight line. This is because the loom has a high speed and high friction, and the side support is not assembled in a standardized position, which will lead to edge defects and easily wear the steel box in severe cases. It is recommended that the operator of the opener clean the entire machine after use. Not only the gauze device and tension device need to be inspected, but also the side support customization needs to be repaired. I hope the above content can help everyone improve the efficiency of the equipment. If you want to know more, please pay more attention to the update of our website!