Summary of the future trend of flower machine development

The use of flowering machines is mainly divided into non-woven flowering and cotton flowering. The most used is non-woven flowering machines. Especially in recent years, with the rapid development of non-woven fabrics in vegetable greenhouses, the development momentum of related supporting equipment in my country is even stronger. The manufacturers of opening machines mainly summarize the following three future trends. 1. High yield and high efficiency This is what all our non-woven and cotton manufacturers like, and it is also a very important point. Due to the huge output of non-woven products, only efficient flowering machines as a backup force can catch up with the production of acupuncture equipment. 2. Start to develop in the direction of semi-automation Until 2012, all flowering machines and other supporting equipment were basically manually operated. Starting this year, it has begun to develop in the direction of semi-automation. In this way, the operating force is greatly improved, and on the other hand, the cost of mixing is greatly reduced. 3. Multi-functional integration used to be dominated by a single flowering function, but recently it has begun to integrate comprehensive functions such as flowering and tangent. It is the main direction of the development of flowering machines in the past two years, and it is also a function that many companies are competing to develop. Matters needing attention in the use of flowering machines: 1. The beating speed of the flowering machine directly affects the impact strength of the beating on the cotton layer. When the cotton feeding method is fixed, the jacquard machine has a high speed and the cotton wool removal effect is good. However, if the speed is too high, the impurities are easy to break. Shaking the white flowers and tying the cotton bales will reduce the impurities in the cotton wool. When processing raw materials with long fibers, few impurities or low maturity, low beating degree is usually used. 2. The distance from the jacquard machine to the cotton roller of the cotton machine affects the tearing force of the jacquard machine blade entering the cotton layer. The smaller the distance, the better the opening effect, but if it is too small, it will not damage the optical fiber. The A036 porcupine cotton opener is suitable for spinning cotton fibers below 31mm. The spacing cannot be adjusted with 6mm. When processing chemical fibers, the comparison distance is 11mm. 3. The spacing between the jacquard machine and the dust collector gradually slows down, the volume increases, and the spacing between the inlet and the outlet gradually increases. If the spacing is small, the chance of the cotton block being blocked by the dust rod will increase, and the amount of lint will also increase. On the contrary, the larger the spacing, the less fluff. Generally speaking, medium-sized yarn is spun, with an inlet spacing of 10~12 and an outlet spacing of 17~18.5. Since this distance is not easy to adjust, it is generally not adjusted when the properties of the raw cotton do not change much. 4. The distance from the flower machine to the cotton stripping knife is very small, generally 1.5~2 mm. If it is too large, the flower machine will easily return the flower and spit silk. In the dust box, the airflow increases more and the impurities decrease, so its spacing is smaller.