Introducing several important steps to maintain the opener

In the normal textile industry, the use of opening machines is indispensable. Without this equipment, it is impossible to carry out preliminary processing of raw materials. Therefore, the maintenance of this equipment is related to whether the work efficiency can be maintained. Therefore, in addition to strengthening the management of the staff, the manufacturer should pay more attention to the maintenance of this equipment. (I) Cleaning of the whole machine 1. Open the protective cover outside the pressure gauge of the equipment, pull open the control box, and clean the whole vehicle. Blow off the bristles in the electromagnetic clutch (this is the key part that causes the flame accident) to wipe off the oil stains around the pedal box. Clean the filaments in the control box. 2. Loosen the warp yarn and take out the fancy wool under the heald and the breast beam. Too many flowers and hair under the breast beam will damage the air pipe of the auxiliary nozzle. Too many flowers and hair at the bottom of the steel box can easily cause the box road or damage the street teeth. 3. Blow off the lint under the hinge of the heald frame, remove the oil stains under the cloth roller, blow off the lint on one side of the warp feeding motor, and then clean it after the machine. 4. Cleaning of the weft storage device: clean the flying flowers in the winding disk and the floating flowers around the tensioner. 5. Cleaning of the selvedge machine: Cleaning the selvedge is the key to reducing burrs and defects, and it needs to be cleaned carefully. (ii) Check the leno device and tension device of the opener 1. Eliminate dust and accumulated filaments between the sliders on the leno edge. 2. Check the needle guide and yarn guide to keep them smooth. 3. Check whether the warp is correct and whether the twisted edge is working. 4. Check whether the tension proximity switch and damper are working and whether the screws are loose. (iii) Inspection of the side support 1. If conditions permit, there should be side supports. 2. When there are no conditions, remove the side support rod and carefully check whether the side support rod teeth are bent or damaged. 3. Check whether the tooth ring of the side support rotates flexibly and remove the thread on the tooth ring 4. Carefully check whether the two nylon rings are worn, because after the nylon ring is damaged, one will reduce the stretching effect and the other will cause wear marks on the surface of the fabric. 5. The assembly specifications of the side support should be strictly required. In particular, the cloth edge at the side support, the warp yarn at the steel box edge, and the warp yarn at the heald frame edge need to be in a straight line. This is because the loom has a high speed, high friction, and irregular side support assembly, which can cause edge defects and easy wear of the steel box. The above is an analysis of several important steps for maintaining the opening machine. I hope it will be helpful to everyone. If you want to know more about the opening machine, please pay attention to our website dynamics. We will continue to push relevant product content to you and look forward to your consultation.