What factors affect the use of the opener?

The use of the opener is to process some materials like animal husbandry. What process operations are affected during the use of the opener? Maybe everyone is not very clear. Today, let's take a closer look. 1. The beating speed of the corkscrew directly affects the beating strength of the cotton layer. If the cotton worms are beaten regularly, the beater speed is fast, and the opening and removal of foreign matter are very good, but if the speed is too high, the impurities are fragile, the white flowers or dense cotton balls are easy to shake, and the impurity content in the black stigma is reduced. The speed of the beater is usually 50,000 rpm. When processing long-fiber, low-impurity or low-maturity original bridges, low black gangs are usually used. 2. The gap between the beater and the end roller of the corkscrew affects the tearing force of the beater blade deep in the surface layer. The gap is small and the opening effect is good, but it is too small to damage the fiber. The A036 Japanese hedgehog corkscrew is suitable for spinning cotton fibers below 31 mm, with a spacing of 6 mm and cannot be adjusted. For chemical fiber processing, the standard distance is 11mm. 3. The distance from the agitator to the dust bar gradually widens and gradually increases as the cotton mass gradually increases, and this distance gradually increases from the entrance to the exit. The narrower distance increases the possibility of the cotton swab being blocked by the cotton swab, and the cotton swab increases. On the contrary, if the specification is larger, the burr will be reduced. For medium-sized yarns that rotate normally, the inlet specification is 10-12mm and the outlet specification is 17-18.5mm. Since these gauges are not easy to adjust, they are usually not adjusted if the raw material properties rarely change. 4. The distance between the beater and the wire stripper of the can opener should be smaller, usually 1.5-2mm. If it is too large, the beater will easily return to the flower and expose the wire. In general, the use of the opener facilitates our processing process and provides strong help for adjusting the appropriate material size, etc. I believe that through the above process operations, everyone has a closer understanding of the opener.