Problems that are prone to occur in the transmission device of the opener

In the textile industry production line, the opener is the initial device of production. It can pass the raw materials into the equipment through the transmission device, loosen them, remove various impurities, mix them evenly, and output usable textile fibers. Then the transmission equipment is the device that is more prone to problems. Let us analyze the problems that are prone to occur today. The process speed range in the non-woven production line is mainly 5m/min~20m/min. According to the specific process, the frequency of the opener used is also different. Among them, the motor below 50Hz mainly outputs constant torque. In order to ensure the normal and stable operation of the high and low speed sections in the working project, when selecting the capacity of the frequency converter, the power of the AC frequency converter motor should be increased accordingly. In the unit machine, static performance and dynamic performance are equally important. By optimizing the corresponding parameters in the frequency converter and other adjustments, a more satisfactory static performance can be achieved. At the same time, after the on-site actual measurement and theoretical comparison are realized, the parameters are adjusted in the PLC program for calibration to eliminate the static deviation caused by objective conditions in the theoretical calculation. Then, dynamic synchronization is also very important. Its significance mainly refers to whether the linear speed change of the unit machine is consistent during the speed increase and decrease. Heterogeneous automation has now become a bottleneck in modern manufacturing engineering technology, especially for information integration in large-scale system integration projects. Whether in the enterprise construction stage or in the long-term development stage after investment, choosing the right equipment with obvious advantages is a correct choice. With the continuous development of science and technology in my country, the corresponding products in my country have also been enriched and developed. I believe that in the near future, the textile industry will develop rapidly. The above is an introduction to the problems that are prone to occur in the transmission device of the opening machine. I hope it can be helpful to everyone. If you want to know more about the opening machine, please pay attention to our website dynamics. We will serve you wholeheartedly and look forward to your consultation.