"Talking from experience" What operations mainly affect the loosening machine!

After the opener is installed, it also needs to be tested. There are certain test requirements during the test. As a flower machine manufacturer, you only need to choose a floor greater than or equal to 8 square meters for installation (do not fix it with screws. Rubber plates are placed at the bottom of the four feet to ensure the flatness of the four corners of the machine so that the whole machine is free of vibration. After starting to run, first check whether all rotating parts and bolts are loose and falling off. Add an appropriate amount of lubricating oil to transmission parts such as sprockets and gears. After the direction of rotation is determined, start the motor. Since the gear roller starts to run at a high speed, after the gear roller reaches normal operation, start the power supply of the feeding fan, determine the direction of rotation, and then feed evenly. Before stopping, all raw materials in the machine need to be processed and then the power supply is cut off. On the feed side of the conveyor belt, a reverse switch is installed. In the event of an accident, stop or reverse immediately. This allows the machine to operate normally. What operations are mainly affected! 1. The beater speed of the opener directly affects the strength of the beater's attack on the cotton layer. When the cotton is timed and the beater speed is high, the cotton opening and impurity removal effects are good. However, if the speed is too high, impurities are easy to break, white flowers are easy to swing or the cotton bundles are too tight, which will reduce the impurities in the fallen cotton. The beater speed is generally 5000 rpm. When processing raw bridges with long fibers, few impurities or poor maturity, a lower beating degree is usually used. 2. The distance from the beater to the cotton roller of the opening machine affects the tearing force of the beater blade to penetrate the cotton layer. The smaller the distance, the better the opening effect, but if it is too small, it will not damage the optical fiber. 3. The spacing from the beater to the dust rod gradually becomes looser and larger from the entrance to the exit. When the spacing is small, the probability of the cotton block being blocked by the dust rod will increase, and the amount of lint will also increase. On the contrary, when the spacing is large, the cotton lint is reduced. Generally, medium-sized yarn is spun with an inlet spacing of 10~12 mm and an outlet spacing of 17~18.5 mm. Since this distance is not easy to adjust, it is generally not adjusted when the properties of the raw cotton do not change much. 4. The interval between the beater and the stripping knife of the opener should be smaller, generally 1.5~2 mm. If it is too large, it is easy to return the flowers and cause the silk to fall off. The opener is a very popular equipment in the old clothes recycling industry. Its application advantages are very significant, but we remind everyone to regularly check whether there is any metal on the magnet and remove it. Especially when there is metal foreign matter in the cotton conveying tube, the magnet should be checked to find the metal foreign matter and prevent it from entering the equipment. I hope the above content can help everyone!