Analysis of common processing techniques when using the opening machine

As a fiber loosening equipment, the opening machine is widely used in various textile industrial sites. In order to spin high-quality fine yarn, it loosens the raw materials, removes various impurities, and then mixes them evenly day after day. Today, Jinan Xinjinlong Machinery analyzes the common processing technology when using this equipment. Due to the wide variety of spinning raw materials, the fiber properties and impurities contained are different, so the process of raw materials is also different. In cotton spinning, the opening of raw cotton is an independent process, which is carried out on the opening and cleaning combined machine. While the raw cotton is loosened, additional effects such as mixing, impurity removal, and dust removal are produced. In wool spinning, the opening of raw wool is often combined with wool washing, wool drying, and wool mixing, using a combined opening, washing, drying, and wool mixing machine. In silk spinning, the opening and impurity removal of fine cotton are carried out during the cotton making process. The opening quality of various fiber raw materials is mainly determined by the process, and different process principles should be adopted for different raw materials. For example, when processing raw cotton in cotton spinning, the process principles of loosening first and then beating, more loosening and less return, reasonable blow, early falling and less broken are adopted. When using an opening machine to process chemical short fibers or medium and long fibers, since the chemical fiber raw materials are relatively fluffy, do not contain impurities, and only contain a small amount of fiber defects, the process principle of more combing and less beating, less elimination and more recycling is adopted. According to the principle, the cotton opening and cleaning machinery and configuration process are combined. Raw materials that are packed too tightly, contain too much water or contain too much impurities should generally be pre-treated. Tightly packaged raw materials should be pre-opened, or unpacked first to give them sufficient time to loosen naturally; raw materials with too much water should be dried before opening to improve the opening effect of the raw materials. The above content is the common processing technology when using an opening machine, and I hope it can be helpful to everyone. If you want to know more about the product knowledge of the flower opening machine, please pay attention to our website dynamics. We will serve you wholeheartedly and look forward to your consultation.