The quilt production line editor will tell you that the quilt production line and the fabric can be organized and structurally designed. The fabric has a different organization, and the number of interlaced points of the warp and weft in the fabric is different. Under the same conditions of other development conditions, the interlaced points of the warp and weft are different. More, the beating-up work resistance is large, and the width of the beating-up area of the quilt production line is also large. Special equipment for the textile industry on the winder. As the last process of spinning and the first process of weaving, winding is the link between the past and the next.“bridge”Therefore, it occupies an important position in the textile field.
Grinder A spinning machine that turns fiber strands into rovings. The main function is to draft and twist, and to wind the roving into a certain package to meet the processing requirements of the spinning frame. During the spinning process of the spinning frame, the semi-finished roving or sliver is drafted, twisted, and wound into a spinning machine. The combed sliver and the needle-carding machine combine the sliver, the needle row is drafted to improve the sliver structure, and the roving is further spun into spun yarn on the ring spinning frame, which is the main spinning machine.
Increasing the warp, weft density and tightness of the fabric will increase the beating resistance and the beating area, but the influence of the weft density is far greater than the warp density. Since J1, high weft density fabrics are more difficult to beating weft than high warp density fabrics. In practical production, the weft density of the fabric is often smaller than the warp density. One of the main reasons for the problem is to make it easier to weave, and learning together is also beneficial to social progress. Enterprise output. The opening time of the quilt production line The morning and evening of the opening time of the quilt production line determines the height of the ridge and the tension of the warp during beating. The resistance is increased accordingly, because the front angle of the bobbin shell at the end of the beating-up is large, and the weft yarn is not easy to be reversed and retreated, so that the movement of the cloth fell is reduced. Therefore, the opening time of the beating-up area should be determined according to the type of fabric. Take into account the coordination of other processes.
If the opening time is too early, the front angle of the shed is large during the beating, and the skew length of the warp yarn is also large, so the conflict length of the box teeth on the warp yarn will increase, which will accelerate the damage of the yarn surface and increase the end breakage. Whether the kneading degree of the shuttle when entering and exiting the shed should be taken into account sooner or later at the opening time.