The grooming fingers are fixed to the windings in the longitudinal position of the moderate foot guide channel (L1) (requires easy adjustment of the teeth). During the spinning process of the spinning frame, the semi-finished roving or sliver is drafted, twisted, and wound into a spinning machine. The combed sliver and the needle-carding machine combine the sliver, the needle row is drafted to improve the sliver structure, and the roving is further spun into spun yarn on the ring spinning frame, which is the main spinning machine. The structure of the double twisting unit of the double twisting machine mainly includes the spindle braking device, the spindle part of the double twisting machine, the yarn winding device, and the special device of the double twisting unit.
Special equipment for the textile industry on the winder. As the last process of spinning and the first process of weaving, winding is the link between the past and the next.“bridge”Therefore, it occupies an important position in the textile field. After the crankshaft is bent to the abandoned position, at the cargo street with the wound lead root, the volume hook contacts the retaining hook and takes three teeth halfway from the retaining hook (eg, solid 3-29? shown).
If it is four-and-a-half teeth, although it can be coiled, because the inclination of the coiling rod (L4) is too large, the coiling hook (L~) and the saw wheel are not in line, but also in surface contact. Section: The situation is more prone to wear and tear on the coiling hook. If we need to return the teeth and weave cloth at this time, the take-up hook cannot be fully lifted. If it is two and a half teeth, when the bending shaft rotates from the upper center to the front center, the coiling hook is easy to collide with the economic holding hook, and the control function of entering the coiling is lost. The determination of the relative position of the anti-reverse hook of the carding machine is maintained. The clearance between the anti-backlash hook and the root of the take-up wheel should be maintained at 1.6 mm (- 1 inch) with the hook in contact with the base of the take-up wheel (as shown in Figure 3-1629).
The principle of this assembly is 1. The national zigzag rounds are cast, and the spacing is not necessarily equal, so there is room to make anti-back hooks and zigzag teeth root points, which can make Yajian Hospital's pins and each beep with love. 2. It will be affected by the wear and tear of the enterprise if it can be hooked together in operation. If the grinding wheel is 1.6 mm, the anti-retraction hook can still control the reverse amount of the sea surface with the sawtooth wheel.
cotton fabric waste recycling machine
Fabric Waste Recycling Machine