The company was founded in 1998,  a professional Fabric Recycling Machine Manufacturer in China.


Carding machine stripping fault problem

Author:Xinjinlong Machinery-Fabric Recycling Machine Manufacturer

1. If the leather wings of the carding machine are worn or the distance between the leather wings and the dust-proof cage exceeds the dog, the cotton layer on the dust-proof cage cannot be removed smoothly. Special equipment for the textile industry on the winder. As the last process of spinning and the first process of weaving, winding is the link between the past and the next.“bridge”Therefore, it occupies an important position in the textile field.

The structure of the double twisting unit of the double twisting machine mainly includes the spindle braking device, the spindle part of the double twisting machine, the yarn winding device, and the special device of the double twisting unit. Carding machines are used to process cotton fibers and chemical fibers and belong to textile machinery. According to the spinning process, carding is an important process.

The front process of the carding machine is the opening and cleaning machine, and the latter process is the drawing frame (carding process) or the sliver coiler (combing process). 2. The amount of cotton stored in the cotton box of the carding machine is too high, especially the main reason for the vibration of the fan of the carding machine that connects the condensing reel and the rear working machine. 1. The fan is called - around the flower. 2. The hole of the fan belt plate of the quilt production line is worn. 3. The fan bearing is worn.

Solution: 1. Often do the fan blade wheelchair grab to prevent flowers from getting around. 2. Extend the length of the fan pulley sleeve. 3. Replace the bearing, pay attention to bearing maintenance.

4. Correct the position information of reset cam and clutch gear. 5. Auxiliary axis left and right position calibration, general positioning. A small fastener on the right side of the machine can be flush with the countershaft head.

Reasons for the continuous pressure head 1. The technical auxiliary shaft of the quilt production line moves left and right during operation, and the pull-out pin is inserted into a passive control clutch groove when it is reset, causing some auxiliary shafts to continue to rotate, resulting in continuous pressure head of the enterprise. 2. The upper sleeve of the pull pin falls off, and the clutch ladder gear cannot be disassembled, so the countershaft rotates continuously and the machine head is continuously pressed. 3. The spring force of the pull-out pin is insufficient, and the pull-out pin is inflexible, so that the pull-out pin cannot be reset after being pulled out, resulting in a continuous pressure head.

Solution: 1. Adjust the left and right position e of the auxiliary shaft and fasten the screws fastened at both ends, so that the auxiliary shaft does not move left and right during operation. 2. Check and pull out the pins. 3. Replace the pin-pulling spring and make the economic activities up and down the pin-pulling flexible.


cotton fabric waste recycling machine

Carding Machine Manufacturer

Fabric Waste Recycling Machine

Baling Machine Manufacturer

Cotton Cleaning Machine

Just tell us your requirements, we can do more than you can imagine.
Send your inquiry

Send your inquiry

Choose a different language
Қазақ Тілі
Current language:English